A ________ is an electromagnetic device that can be used to control fluid pressure in a hydraulic circuit

A) TCM B) Solenoid
C) Neutral start switch D) Vehicle speed sensor


B

Trades & Technology

You might also like to view...

Which of the following statements is LEAST-Likely true?

A. If tires are to be replaced, the new tires should be installed before attempting an alignment. B. When correcting for road crown, camber creates less of a pull than caster. C. Caster causes the camber angle of the wheel to change during a turn. D. Roads are crowned (higher at the center than the outside) so that rain will run off.

Trades & Technology

Slanted letters are intended to suggest the way most people write; so they slant to the right at about what degree of angle?

a. 45 degrees c. 90 degrees b. 60 degrees d. 30 degrees

Trades & Technology

Water molecules have polarity primarily because each contains two H atoms and only one O atom

Indicate whether the statement is true or false

Trades & Technology

A voltage source is used to charge an automotive battery as shown in Figure P9.65(a). At t = t1, the protective circuitry of the source causes switch S1 to close, and the source voltage goes to zero. Find the currents IS , IB, and ISW for the following conditions:

a. t = t ? 1
b. t = t + 1
c. What will happen to the battery after the switch closes?
Now we are going to charge the battery, using the circuit of Figure P9.65(b). Repeat parts a and b if the diode has an offset voltage of 0.6 V.

Trades & Technology