In base line dimensioning, all measurements are made from common finished surfaces called base lines or ____ lines.
A. relative
B. connection
C. dimension
D. reference
Answer: D
You might also like to view...
Technician A says that all piston pins are offset from the centerline of the piston. Technician B says that most piston pins are pressed-fit in the connecting rod. Who is right?
A. ?Technician A only B. ?Technician B only C. ?Both A and B D. ?Neither A nor B
____________________ seeding is broadcast seeding of a crop when the ground is frozen
Fill in the blank(s) with correct word
Give the term that describes features that are used for safety on balconies, lofts, stairs, and decks over 30" (760 mm) above the next lower level, and can be used as decorative room divider:
What will be an ideal response?
Which of the following statements is correct?
A. Mode $01 is a scan tools request to access the data stream. B. Mode $06 is a scan tools request to obtain the test results of non-continuous monitors C. Both A and B are correct D. Neither A nor B is correct