If the refrigerant condensing saturation temperature is 100°F at the start of the process, what would the entering water temperature be?
A) 80°F B) 50°F C) 110°F D) 20°F
A
You might also like to view...
In CADD, once the outer edge has been placed, freeze the wall layer and continue to create the foundation stem walls; use the ____ command to lay out the thickness of the stem walls and footings.
A. TRIM B. CHANGE C. BASE D. OFFSET
If plywood panels are used to build a slipforming form, a small gap should be left between panels to allow for _____.
a. pressure equalization b. shrinkage c. swelling d. water runoff
Preparing a house for a future solar array is not complicated and can simplify the eventual installation if done properly. Where there is a south or near-south facing roof, it should be designed to have a minimum of ____ square feet of unshaded area with no mechanical penetrations such as plumbing vents, wires, or other obstructions.
A. 100 B. 200 C. 300 D. 400
If a driver notices that the ammeter registers discharge or there is a low reading on the voltmeter, the driver should
A. stop immediately B. not shut off the engine C. not accelerate D. shift into neutral