When performing an initial system check, a TAB technician determines that the total airflow the blower is moving cannot be adjusted to meet design specifications. This could indicate that:
A) There is no air filter installed. B) There is too much restriction in the ductwork.
C) There are leaks in the supply-side ductwork. D) There are leaks in the return-side ductwork.
Match the type of system to the application.
B
You might also like to view...
What is the current Volvo engine diagnostic software known as?
A. IMPACT B. TechTool (TT) C. Premium Tech Tool (PTT) D. EIS
You are testing a running motor in a series circuit using a voltmeter and identify the following circuit conditions: Voltage measured from motor positive terminal to chassis ground: 8.6 V-DC Voltage measured from motor negative terminal to chassis ground: 0 V-DC Voltage dropped across motor positive and negative terminals: 8.6 volts Where is the problem in the circuit likely to be found?
A. On the positive side of the load B. On the negative side of the load C. The load (motor) D. No circuit problem based on this data
A welder can determine preheat, interpass or postheat temperature by:
A) Measuring the distance from the weld that his crayon will melt B) Using a crayon to get the right color in the weldment C) Using a temperature-indicating crayon D) None of the above
Name a cutting tool that uses a high velocity stream of water combined with an abrasive substance to cut through various materials with compressed fluid at 60,000 pounds per square inch (psi) is forced through a very small orifice, which creates a thin stream of water traveling close to 600 miles per hour (mph)
What will be an ideal response?