What is the purpose of the wedge shown in this drawing?
A) To increase spring capacity
B) To lower vehicle ride height
C) To raise vehicle ride height
D) To correct the driveshaft angle
D) To correct the driveshaft angle
You might also like to view...
Answer the following statements true (T) or false (F)
1) Emergencies are by their nature the result of natural causes only. 2) An immediate response that is the result of planning practice, evaluation, and adjustment is critical in emergencies. 3) One major component in the Emergency Planning and Community Right-to-Know Act is toxic chemical release reporting. 4) In emergency response situations only one person should be in charge. 5) Because of concerns about AIDS, first aid should not be part of emergency response.
The upper surface of a plate is bolted with ASTM B21 naval brass bolts. The bottom surface of the plate is fully insulated. The upper plate surface is exposed to convection at an air temperature of 50°C and a convection heat transfer coefficient of 5 W/m2•K. Also, thermal radiation exchange occurs between the upper plate surface and the surrounding surface temperature of 300°C. The emissivity of the plate surface and the bolts is 0.3. The ASME Code for Process Piping (ASME B31.3-2014) limits the maximum use temperature of B21 bolts to 149°C. Determine whether the ASTM B21 bolts on the plate comply with the ASME code.
A negative shunt clipper with an RS of 1.2 k? and an RL of 6.8 k? is across a sine wave ac source with peak input values of ±15 V. What is VL at the positive peak?
A) 1.5 V B) 2.25 V C) 8.5 V D) 12.75 V
A motor's speed is determined by ____.
A. size B. voltage C. amperage D. number of motor poles