A plug gage tapers 3.10 mm along a 38.00 mm length as shown in the accompanying figure. Determine the amount of taper in a workpiece whose thickness is 15.25 mm. Give your answer in millimeters rounded to two decimal places.
A. 1.24
B. 1.52
C. 1.21
D. 1.13
Answer: A
You might also like to view...
In 1942, J.G. Ziegler and N.B. Nichols published two loop tuning techniques that are still used today by many control engineers and technicians, which are called the ultimate gain method and the ____________________ method.
What will be an ideal response?
The ________ of a company are standards that are important to the organization and customers can count on your company to follow.
A) values B) visions C) mission statements D) all of the above
Which of the following statements about the thermostatic expansion valve is NOT true?
A. The TXV divides the high and low pressure sides of the refrigeration system. B. The TXV monitors the temperature of the evaporator outlet to adjust flow accordingly. C. The TXV uses an equalizer line to sense the pressure at the evaporator outlet. D. If the TXV loses the pressure signal from the sensing bulb it will go to a full open mode to prevent the evaporator from starving.
Check valves are _____ directional-control valves
a. one-way b. two-way c. three-way d. four-way