A throttle position sensor waveform is going to be observed. At what setting should the volts per division be set to see the entire waveform from 0 volts to 5 volts?

A) 5.0 V/Div B) 2.0 V/Div C) 1.0 V/Div D) 0.5 V/Div


C

Trades & Technology

You might also like to view...

A good rule of thumb for safe tire tread is a minimum of ____-inch tread depth.

A. 1/8 B. 1/4 C. 1/2 D. 3/4

Trades & Technology

All of the following statements are true EXCEPT:

A. drive shafts can be aluminum, steel, carbon fiber bonded to aluminum yokes, or composite that is pultruded over an aluminum tube. B. most steel drive shafts are shorter than 60" to 65". C. short steel shafts use a center support bearing. D. aluminum drive shafts can be 85" to 90" because aluminum has a higher "critical speed."

Trades & Technology

Hidden lines are always shown in an isometric sketch.

Answer the following statement true (T) or false (F)

Trades & Technology

Three-wire controls depend on a set of normally open contacts, generally called ____________________, maintaining, or sealing contacts.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology