When the PM crew arrives at the machine, what is the first thing that needs to be done?
A. Close the lockbox
B. Clean the surrounding area.
C. Set up the toolboxes.
D. Lock out all energy sources.
Answer: D
You might also like to view...
____ veneer lumber is intended for use as high-strength, load-carrying beams to support the weight of construction over window and door openings, and in floor and roof systems of residential and light commercial wood frame construction.
a.Hardwood c.Oriental b.Laminated d.Fibrous
Technician A says that synthetic lubricants may be used in truck differential carriers but OEMs have yet to authorize extended oil drain intervals. Technician B says that using synthetic gear lubes is cost effective compared to mineral-base gear lube because of greatly increased oil drain intervals and reduced labor. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
When the worm shaft and bearings are properly installed and adjusted in a power recirculating ball steering gear:
What will be an ideal response?
The following scales and their notations are common to mechanical drawings:
A. FULL or 1:1 B. HALF or 1:2 C. QUARTER or 1:4 D. DOUBLE or 2:1 E. all of the above