To check sheave wear:
A. See if the belt bottoms out in the sheave groove.
B. See if the belts squeal because they can't grip the worn sheave.
C. Measure each groove angle.
D. Use a sheave groove gauge.
D
You might also like to view...
To get the best reading, the refrigerant sensor should be located where?
A) Where the leak is more likely to occur B) Where the leak is less likely to occur C) On the top near the valve D) On the bottom of the tank
When using the ________ configuration, footings and foundations are formed and completed and then the slab is placed at a different time
A) Monolithic slab B) Turned-down slab C) Frost-protected slab D) Independent slab
Most rough sanding done in automotive work is done with a grinder.
Answer the following statement true (T) or false (F)
Which of the following practices would encourage higher soil temperatures in the spring in a humid-temperate area?
A) follow no-till practices with a killed cover crop B) use a plastic mulch C) rototill the soil to leave it fluffy and bare D) irrigate the soil to leave it wet and dark colored E) apply a thick mulch of straw