The most commonly used device for checking footing trench depth is the _____
a. folding rule
b. builder's level
c. telescoping rod
d. laser level
d
You might also like to view...
A dc, separately excited motor has the following data:
Rated field voltage = 300 V Field constant (K?) = 3 Vs Armature resistance = 2 ? Field resistance = 150 ? The motor is used to drive an assembly line consisting of a conveyor belt moving horizontally. The load on the belt varies depending on the amount of goods being moved. The load torque seen by the motor varies from a maximum of 24 Nm to a minimum of 3 Nm. At all loading conditions, the speed of the motor must be maintained constant and equal to 200 rpm. a. To achieve the required operation, the armature voltage of the motor is adjusted by a single-phase, full-wave, ac/dc converter. The input to the converter is 240 V (rms). Calculate the range of the triggering angle (minimum and maximum) required to maintain the motor speed at the specified value at all loading conditions. Assume that the armature current is always continuous. b. Another method to achieve the desired operation is to adjust the field voltage. In this case, the armature voltage can be kept constant at some value. Calculate the range of the field voltage (minimum and maximum). Hints: Assume that the maximum value of the field voltage is equal to its rated value (i.e., 300 V). Also assume that the field constant (K?) is linearly proportional to the field voltage.
Which of these are symptoms of carbon build-up on the throttle plates?
A) Rough idle B) Surging at idle C) Stalling D) All of these are correct.
The perimeter system is often used alongside a core system in:
A) Interior spaces. B) Single-story buildings. C) Larger buildings. D) Older buildings.
On a drawing 1 inch represents 50 feet, if the measurement of a drawing of a plot plan is 3 1/8 inches, determine the actual length to the nearest foot.
What will be an ideal response?