A V groove weld symbol shows (7/16) to the left of the weld symbol along with a 3/8 to the left of (7/16), both of which are under the reference line. The notation "OAWMA" is in the tail. This welding symbol means ____.
A. the weld depth on the arrow side should be 3/8", and the root penetration should be 7/16". The depth of the chamfering should be 1/16". The welding process is to be by oxyhydrogen welding with machine welding.
B. the depth of the chamfering should be 3/8" on the arrow side, the root penetration should be 1/16", and the total weld depth should be 7/16". The welding process is to be by oxyacetylene welding with manual welding.
C. the depth that the weld penetrates the surface should be 7/16" on the arrow side and the root penetration should be 3/8". The welding process is to be by oxyacetylene welding with manual welding.
D. the weld depth on the arrow side should be 7/16" and the root penetration should be 3/8". The depth that the weld penetrates the surface should be 1/16". The welding process is to be by oxyacetylene welding with manual welding.
E. None of the above. This is an incorrect symbol.
Answer: B
You might also like to view...
In semiarid regions, a metal strip called a(n) ____ can be placed on the roof to route runoff on the roof from doorways.
A. diverter B. chase C. valley D. inverter
Refer to the op amp circuit in Fig. 5.71. Calculate i? and the power absorbed by the 3-k? resistor.
 FIGURE 1.png)
Figure 5.71
What is used to ignite the air-fuel mixture in the cylinder of a gasoline engine?
A) Chemical reaction of the air-fuel mixture B) Heat of compression C) An arc at the spark plug D) The primary winding of the ignition coil
Which of the following terms identifies materials whose price is set by market supply and demand?
A) standard products B) items of small value C) made-to-order items D) commodities