Describe the weld required to attach SK5 to SK1.

Refer to Drawing Numbers E492877 R0 and E482878 R0.


3/8?? fillet both sides, typical

Trades & Technology

You might also like to view...

The starter motor converts:

A. Mechanical energy into electrical energy B. Chemical energy into mechanical energy C. Electrical energy into mechanical energy D. Electrical energy into thermal energy

Trades & Technology

Technician A says that the actuation voltage used to drive CR electrohydraulic injectors (EHIs) is typically around 100 volts when they use solenoid actuators.  Technician B says that actuation voltage for EHIs that use piezo actuators is usually much higher than 100 volts. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B.

Trades & Technology

In a parallel RLC circuit just above the resonant frequency, the impedance is:

A) at maximum. B) more inductive. C) at minimum. D) more capacitive.

Trades & Technology

Smaller chillers typically use:

A) Centrifugal or rotary compressors. B) Centrifugal or screw compressors. C) Reciprocating or scroll compressors. D) Rotary or hermetic compressors.

Trades & Technology