What are the three different ways a datum target line symbol may be specified on a drawing?
What will be an ideal response?
ANS:
A datum target line symbol may be specified three different ways on a drawing.
The symbol may be shown and dimensioned on a plan view of the surface to which it is being applied. Where a plan view is not available, the target symbol can be shown and dimensioned in an edge view. Since the edge view of a line is a point, where a line target is shown in an edge view, the point symbol is used. The third method is to show and dimension the line symbol in the plan view and the point symbol in the edge view.
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. Direct mount is a module mounting method where the modules are secured directly to the roof surface. 2. An opaque object allows light to pass through it. 3. The wind load is the structural load caused by the wind and resulting in downward, lateral, or lifting forces on PV modules and mounting systems. 4. A PV system should only be considered “live” when it is in operation. 5. A live load is a structural load that is a result of the weight of temporary items, including people, on the structure while the array is being installed.
A datum feature is a real physical part of the object that may have surface variations.
Answer the following statement true (T) or false (F)
Like a switch, the DLC is able to switch calls
Indicate whether the statement is true or false
Many unsoundness and blemishes are due to excessive stress and strain beyond the endurance of the bone or muscle, injury to a bone or joint, inherited conditions, or nutritional deficiencies.
Answer the following statement true (T) or false (F)