The major components of a centrifugal pump system include all of the following except:
a. volute h. shaft
b. outer casing i. shaft coupling
c. suction eye j. discharge
d. impellers k. pressure gauges
e. wear rings l. flow control system
f. lobes m. shaft bearings and seals
g. motor
Answer: F
You might also like to view...
Roughly how old is WLF construction?
What will be an ideal response?
He was doing the job right, but not doing the right job. Which time management suggestion
is most closely related to this statement?
a. Don’t let adversity defeat you b. Use technology to assist you. c. Manage your own time. d. Distinguish between high- and low-payoff activities. e. All of the above
The usual maximum pressure that should be used when pressure bleeding a brake system is ________
A) 30 psi B) 20 psi C) 70 psi D) 50 psi
Technician A says that a Caterpillar ADEM controller module is used to manage the CX family of Caterpillar on-highway transmissions. Technician B says the reprogramming, calibration, and troubleshooting software required for Caterpillar CX transmission is ET. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B