What is the accumulation of deposits on the surfaces of processing equipment?
A. Scale
B. Erosion
C. Corrosion
D. Fouling
A. Incorrect. Scale occurs as a result of dissolved solids depositing on the inside surfaces of hot equipment.
B. Incorrect. Erosion is the mechanical degradation or wearing away of tower components.
C. Incorrect. Corrosion is the deterioration of a metal by a chemical reaction.
D. Correct. Fouling is the accumulation of deposits (such as sand, silt, scale, sludge, fungi, and algae) on the surfaces of processing equipment.
You might also like to view...
What is the required width of air space between the veneer and the backup?
What will be an ideal response?
Number 40 ribbon would be used primarily for
a. corsages c. wreaths and sympathy flowers b. flowerpots d. small vases
What is the significance of the scale readings on the instruments of most permanent switchboard installations being graduated to include the voltage and current transformer multipliers?
What will be an ideal response?
For the circuit shown below, let vS(t) = 396 cos(2?60t - 30o) V, R1 = 15 ?, R2 = 35 ?, R3 = 46 ?, L1 = 33 mH, L2 = 63 mH, C = 126 ?F
(a) Find impedances ZR1, ZR2, ZR3, ZL1, ZL2, ZC, and phasor VS for vS(t). (b) Find the equivalent impedance Zeq of parallel combination of ZR2 + ZC and ZR3 + ZL2. (c) Find the total impedance Zt seen from the voltage source. (d) Find the phasor for the current I. (e) Find the phasor for load voltage Vo. (f) Find the phasors for I1 and I2.