The Word feature that automatically creates backup versions of the current document is called ________
Fill in the blank(s) with correct word
AutoRecover
You might also like to view...
You will configure the two routers, R1 and R2, with IPv6 so that they can communicate. The routers are missing all the configuration necessary to support IPv6. To establish IPv6 on Cisco routers, there are two basic steps. First, you must configure the routers for IPv6 forwarding. Next, you should configure the interfaces with specified IPv6 addresses. This lab tests your ability to configure support for IPv6 and verify the configuration. The IPv6 addresses are provided in Table 1. You will not use the PCs in this lab.
1. Enter the privileged mode on Router R1 and enter the command to enable IPv6 routing. List the steps required to enable IPv6 routing.
2. Enter privileged mode on Router R2 and enter the command to enable IPv6 routing. List the steps required to enable IPv6 routing.
3. In the next step, you now need to add IPv6 addresses to the WAN interfaces. Add the IPv6 address 2001:C16C:0000:0001:0000:0000:0000:0001/64 to the serial 0/0/0 interface of R1. What command is required to add this address? Add the address and enable the interface.
4. Next add the IPv6 address to the serial interface of R2. You are to use the abbreviated version of IPv6 address 2001:C16C:0000:0001:0000:0000:0000:0002/64, add the address to the serial 0/0/1 interface of R2, and enable the interface. List the command sequence used.
5. Use the command on R1 to observe the address added to the serial 0/0/0 interface. What command is used? What addresses are shown?
6. Issue the show running-config command on R1 and examine the command you a
You use special software called a browser to access the web, and you must know the address of the website you want to access
Indicate whether the statement is true or false
A(n) ____ ad is an advertisement that appears in a webpage, typically near the top or at the side or bottom margins.
A. interstitial B. pop-under C. banner D. pop-up
To remove a total row that appears in a datasheet, click the ____ button on the Home tab.
A. Toggle B. Remove C. Statistics D. Totals