Technician Asays that worn dampers will generally bounce more than two to three times when performing a bounce test. Technician B says camber is the angle most responsible for straight tracking of the car. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: A
You might also like to view...
Answer the following statements true (T) or false (F)
1. In a basement excavation with walls supported by an excavation retention structure, waterproofing is applied to the excavation retention structure. 2. Spruce is a softwood species. 3. Hardwoods are generally used for fine-quality flooring, furniture, and wall paneling. 4. Flat-sawn lumber is dimensionally more stable than quarter-sawn lumber.
What type of electrical drawing is most often used to trace the flow of power through the drawing?
A. pictorial diagram B. single-line drawing C. architectural drawing D. ladder diagram
Technician A says installing a thrust washer between the oil pump and the direct or front clutch will correct torque converter end play. Technician B says the torque converter must be installed in the transmission before checking end play. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
PROBLEM 3.74 Three shafts and four gears are used to form a gear train that will transmit power from the motor at A to a machine tool at F. (Bearings for the shafts are omitted in the sketch.) The diameter of each shaft is as follows: Knowing that the frequency of the motor is 24 Hz and that the allowable shearing stress for each shaft is 75 MPa, determine the maximum power that can be transmitted.
