AISC specifications define three types of steel-frame construction based upon the type of framing connection used. Unless the structural design plans and specifications clearly specify otherwise, which type of connection will the structural steel fabricator provide?
What will be an ideal response?
Simple type
You might also like to view...
When testing a newly reconditioned engine on a chassis dynamometer, what should be done when the maximum coolant temperature is achieved?
A. immediately switch off engine B. back-off on power and monitor gauge C. ignore it until the test report is complete D. immediately shift into neutral
A low resistance path, which results in a high value of current that flows around, rather than through, a circuit is called a(n) __________ circuit.
a. open b. short c. grounded d. grounding
Transformers in which the primary and secondary voltages are 180 out of phase are known as _____
a. unlike-wound transformers b. like-wound transformers c. unequal transformers d. step-up transformers
Why are split-system installation valves typically NOT used following installation?
A) They do not control flow to service ports. B) They are usually stuck in the closed position. C) They limit flow to the service ports. D) They are usually stuck in the open position.