A corner finisher operates on the same principle as a flat finisher or nail spotter, but its dispensing surface
has an angle of _____.
a. 30 degrees
b. 45 degrees
c. 90 degrees
d. 120 degrees
c
You might also like to view...
Refrigerants that have a low Ozone Depletion Potential (ODP) will, in turn, have a high "Total Equivalent Warming Impact" (TEWI).
Answer the following statement true (T) or false (F)
Which of the following is not a standard digital code?
A) BCD B) ARRL C) ASCII D) Gray
If a situation calls for a TTL circuit to drive a CMOS circuit, you should:
A) do nothing special. A TTL should be able to drive CMOS IC without any problems. B) ensure that both chips have the same fan out. C) ensure that the electrical parameters for both ICs are compatible. D) ensure that the two ICs are pin compatible with each other.
Problem 1.14 Two hydraulic cylinders are used to control the position of the robotic arm ABC. Knowing that the control rods attached at A and D each have a 20-mm diameter and happen to be parallel in the position shown, determine the average normal stress in (a) member AE, (b) member DG.
