Which of the following is NOT a purpose of undercutting?
A. To remove a fillet where the diameter of the part increases
B. To provide a gripping surface
C. To produce a recess in a cylindrical part
Answer: B
You might also like to view...
List four factors that must be considered when calculating what size heater is needed to heat a
greenhouse structure.
What will be an ideal response?Why is the control of obsolescence and knowledge of what parts are selling or not in the parts department so important?
What will be an ideal response?
Wireless media does not suffer from signal losses as do physical media like copper wire or fiber optic cable
Indicate whether the statement is true or false
Consider the piping system shown in the accompanying figure. The speed of water flowing through the 4-in.-diameter section of the piping system is 3 ft/s. What is the volume flow rate of water in the piping system? Express the volume flow rate in ft3/s, gpm, and L/s. For the case of steady flow of water through the piping system, what is the speed of water in the 3-in.-diameter section of the system?
