A seat belt pretensioner is ________
A) Used to remove slack from the seat belt in the event of a collision
B) Used to force the occupant back into position against the seat back in the event of a collision
C) A device that contains an explosive charge
D) All of the above
D
You might also like to view...
?How should the conduit or an extension be aligned with the grooved roller?
A. ?These parts are preset in the factory and must not be changed in the field. B. ?They should be lightly touching the rollers so that the welding current can flow down the wire to the welding gun. C. ?½ in. (13 mm) from the grooves in the roller to prevent arcing. D. ?Set as close as possible without touching the roller.
On a 50 division inch vernier height gage, the vernier index is coincident at the 23rd line. This means that ________ of an inch would be ________ to the beam reading
A) .230; subtracted B) .023; added C) .0023; added D) .230; added
Technician Asays electric assist can only be applied at the steering column. Technician B says belts should be inspected during routine service and often require replacement every 60,000 to 90,000 miles. Who is correct?
A. A only B. B only C. both A and B D. neither A nor B
Typically a small ____ tip is preferred for general printed circuit board work.
A. conical B. bevel C. pyramid D. chisel