A low-pressure switch connects the compressor or the coil of the compressor contactor to terminal ________
A) 3, since it is for the time delay
B) 4, since it is part of the normally closed contacts
C) 4, since it is part of the normally open contacts
C
You might also like to view...
The output produced in bushels and the prices of this output ($/bushel) over the last three years for Seth Johnson, a farmer in Amarillo, Texas, are as follows:
Let the base year be 2011. Relative to 2011, output for 2010 was lower by ________ percent.
A) 13.3
B) 6.67
C) 6.25
D) 7.14
Technician A says that the decision about when to replace a part can be based on the manufacturer’s recommendation. Technician B says that the cost of repair is often used to judge if a part should be replaced instead of being repaired. Who is correct?
A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B
When the desired section has been cut out and is not seen elsewhere on the drawing, ____.
A. an aligned section is used B. an auxiliary section is used C. a revolved section is used D. a broken out section is used E. none of the above
What are the two most common methods of circuit protection in structures?
What will be an ideal response?