Freehand sketches use the same types of lines as working drawings.
Answer the following statement true (T) or false (F)
True
You might also like to view...
Mowing grass too low is referred to as ____________________
Fill in the blank(s) with correct word
The maximum allowable difference between the front and rear working angle of a drive shaft is ________
A) 3 deg B) 1/2 deg C) 1/4 deg D) 1 deg
Two technicians are discussing inspection of the transmission pan. Technician A says that some friction material at the bottom of the pan is normal. Technician B says that if any metal parts stick to a magnet then further investigation is needed to determine the cause. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
If there is too much primary air, the gas flame can ____.
A. get blown out B. "lift" off the burner rack C. make noise D. both b and c