The proper brake bleeding sequence for a front/rear split hydraulic system is ________
A) Right front, right rear, left front, left rear B) Right rear, left front, right front, left rear
C) Right rear, left rear, right front, left front D) Left front, left rear, right front, right rear
C
You might also like to view...
Where does a subcontractor usually obtain the submittal information and shop drawings that are used to
make up a submittal sheet? a. From the construction project's architect b. From previously archived specifications and submittals c. From equipment and accessory manufacturers d. From relevant schedules and site plans
What is the measure of angle C to the nearest degree?
Fill in the blank(s) with the appropriate word(s).
Suppose the current through a wire is given by the curve shown in Figure P2.9. a. Find the amount of charge q that flows through the wire between t1 = 0 and t2 = 1 s. b. Repeat part a for t2 = 2, 3, 4, 5, 6, 7, 8, 9, and 10 s. c. Sketch q(t) for 0 ? t ? 10 s.
What will be an ideal response?
What safety precaution should you follow when opening the split system installation valves?
A) make sure they are securely frontseated before operating the system B) always make sure they are securely back-seated C) do not over-tighten in the back-seat direction D) make sure that are front-seat cracked before operating the system