What is the usual setting for the limit on the fan/limit switch of a warm air furnace?
A) 180°F to 200°F B) 250°F to 300°F C) 120°F to 150°F D) 80°F to 100°F
A
You might also like to view...
Often, compound angle problems are encountered when machining parts as shown on engineering drawings. Usually, the top, front, and ____________________ views of orthographic projections are shown.
Fill in the blank(s) with the appropriate word(s).
Which of the following terms has the same meaning as landing gear on a trailer?
A. duals B. tandem axle C. dolly legs D. lift axle
If a schematic diagram shows a clear path from L1 to L2, without passing through any load, then what condition exists in the circuit?
A) Normal condition B) Feedback C) Open circuit D) Short circuit
What happens when the microcontroller is ready to read data from the EPROM?
A) The PSEN line goes LOW. B) The ALE line goes HIGH. C) The PSEN line goes HIGH. D) The ALE line goes LOW.