How would you remove excess fluid from the transmission?
What will be an ideal response?
Excess fluid can be removed by one of the following methods:
1. Loosen and remove one of the transmission cooler lines from the radiator. Run the engine to pump ATF out into a pan. Be sure to use two wrenches (one of them a flare-nut wrench) to prevent damage to the radiator.
2. Through the transmission dipstick hole, you can use a hand suction gun or a solvent siphon gun connected to shop air.
You might also like to view...
The heat load for a cooling tower is equal to the pounds of water circulated multiplied by:
A) The approach. B) The cooling range. C) The latent heat factor for vaporizing water. D) The wet-bulb depression.
The term quarter-sawed means _____.
______________________________ involves clamping the vehicle down so that it will not move during the straightening process.
Fill in the blank(s) with the appropriate word(s).
Chamfering is ____.
A. the rounding of a corner B. the lengthening of a shaft C. the cutting of a groove D. the addition of material to a part