Ride height should be checked ________

A) Side to side B) Front to rear
C) To be within manufacturer's specifications D) All of the above


D

Trades & Technology

You might also like to view...

A decision support system automatically searches for, analyzes, summarizes, and reports

information needed by a manager for a particular decision.

Indicate whether the statement is true or false.

Trades & Technology

Many technicians always use new pushrods because ________

A) They wear at both ends B) Pushrods shrink in length if removed from an engine C) They are ess expensive to buy than clean D) All dirt cannot be cleaned out from the hollow center

Trades & Technology

When pressurizing a system for leak testing, a safe maximum test pressure is typically _____

a. 50 b. 75 c. 125 d. 250

Trades & Technology

The primary reason for a DC series motor runaway condition is __________.

A. the armature current increases faster than the CEMF B. the CEMF does not increase as fast as the motor speed C. the CEMF increases faster than the motor speed

Trades & Technology