In gang milling, the RPM of the spindle is calculated for cutters with the:
A) Narrowest width B) Greatest width C) Largest diameter D) Smallest diameter
C
You might also like to view...
Outline the best approach for using performance data in oral reasons.
What will be an ideal response?
What will a Zener diode do at breakdown voltage?
A. Allow reverse current to flow B. Stop the flow of reverse current C. Sustain damage as a result of current overload D. Stop the flow of either forward or reverse current
(a) Sketch the deflected shape of the frame in Figure P5.48. Reactions and moment curves are given. Curvature is also indicated. Joints B and D are rigid. The hinge is located at point C. (b) Using an origin at A, write the equations for shear and moment in member AB in terms of the applied load and the distance x.
If the resistance of the cad cell is too high, you should:
A) Close the circuit. B) Reset the switch. C) Replace the cad cell. D) Repair the cad cell.