Which of the following can be used to bend IMC?
a. A reamer
b. A hickey
c. A die
d. A hacksaw
b. A hickey
Trades & Technology
You might also like to view...
A balance sheet is like a photograph of the business at a given time
Indicate whether the statement is true or false
Trades & Technology
PROBLEM 3.122
Determine the largest allowable length of a stainless steel shaft of cross section if the shearing stress is not to exceed 15 ksi when the shaft is twisted through 15?. Use
Trades & Technology
One type of injection system does that does not hold pressure when turned off is called a non-checking system. This is found on ________
A) Multiport injection systems B) All TBI systems C) Some General Motors TBI systems D) None of these
Trades & Technology
Template jigs are best used when speed is the prime consideration.
Answer the following statement true (T) or false (F)
Trades & Technology