Is part number 3 welded all the way around?

Refer to the girder brace in Drawing Number W11784S R1.


No

Trades & Technology

You might also like to view...

What should you do before lifting or lowering the hood on a conventional truck?

A. Make sure all hood dampers, springs, and cable stays are attached. B. Check that no one is under the hood before closing. C. Verify that there is sufficient room in front of the truck before opening the hood. D. All of the above.

Trades & Technology

Bob’s drill broke down and was in the shop 3.5 days. A mechanic worked 15.2 hours to repair the drill at $78 per hour and replaced $1,367.86 worth of parts. Bob estimated it cost him $22 per hour for not having use of his drill. He works 12-hour days.

a. What was the cost of repairing the drill? b. How much did it cost by not having the use of the drill? c. What was the total cost?

Trades & Technology

At what angle (in degrees) to the ground should the stakes be when used to guy a tree?

a. 30 c. 60 b. 45 d. 75

Trades & Technology

Technician A says the hypoid gearset was designed to lower the body profile. Technician B says hypoid gears provide for smoother and quieter action. Who is correct?

A. A only B. B only C. both A and B D. neither A nor B

Trades & Technology