_____ force tends to pull the object toward the center of the circle, whereas _____ force tends to push the object away from the center.

A. Centripetal; centrifugal
B. Centrifugal; centripetal
C. Centripetal; gravitational
D. Centrifugal; balanced


Answer: A

Trades & Technology

You might also like to view...

Repeat Problem below for IMT2000 system.

Assuming that by infrastructure, we mean that these employees’ primarily objective is to communicate with each other. (a) If all the employees are located in the same city, then very small cells have to be used in order to accommodate them all where cell splitting will occur. The density would be very high. (b) Larger cells would be used if compared to the ones used if all employees were in one place. The density would be average. (c) Even larger cells would be used if compared to the ones used in the previous Problem. The density would be low. (d) In this case, the GSM can make use of its compatibility across systems and even makes use of satellite systems to accommodate its users over all places over the world.

Trades & Technology

Obtain a copy of a Transportation Research Record: Journal of the Transportation Research Board (published by the Transportation Research Board).

What will be an ideal response?

Trades & Technology

Narrowleaf evergreen cuttings benefit from a misting system

Indicate whether the statement is true or false

Trades & Technology

The typical start up sequence for a hot surface ignition system is:

A) Combustion blower prepurge, igniter energized after a delay, gas valve energized after a delay, flames sensed, indoor blower energized after time delay. B) Combustion blower, indoor blower, igniter, and gas valve all energized simultaneously. C) Gas valve and igniter energized, flames sensed, combustion blower and indoor blower energized after time delay. D) Combustion blower energized, igniter energized and gas valve energized, flames sensed, indoor blower energized after time delay.

Trades & Technology