How is voltage drop through the power wire to the unit checked?
A) The difference between the minimum and maximum allowable nameplate voltages is the voltage drop
B) The difference in voltage before and after starting the furnace is the voltage drop
C) Measure the resistance of the power wire from the source to the furnace and multiply it times the furnace operating current
D) The difference between the nameplate voltage and the actual operating voltage is the voltage drop
B
You might also like to view...
What should be used to lift a crankshaft from an inverted cylinder block?
A. yoke with rubber conduit over throw hooks B. wire braided slings C. hemp braided rope D. heavy duty chain
How does brush placement control the speed of a permanent magnet windshield wiper motor?
What will be an ideal response?
If there is too much curve to the horse's legs, undue strain will be placed on the muscles of the legs and the ____________________.
Fill in the blank(s) with the appropriate word(s).
Which of these facts is correct about a delta-wound stator?
A) The windings always form a series circuit B) No neutral junction C) No ground connection D) The circuit diagram looks like a parallelogram