Recall that the function of a water tower is to create a desirable municipal water pressure for household use and other usage in a town. To achieve this purpose, water is stored in large quantities in elevated tanks. Also recall that the municipal water pressure may vary from town to town, but it generally falls somewhere between 50 and 80 lb/in2 (psi). In this assignment, use Excel to create a table that shows the relationship between the height of water above ground in the water tower and the water pressure in a pipe line located at the base of the water tower. The relationship is given by:

P = pgh
where
P = the water pressure at the base of the water tower (lb/ft2)
p = the density of water, (rho) = 1.94 slugs/ft3
g = the acceleration due to gravity, g = 32.3 ft/s2
h = is the height of water above ground in feet (ft)
Create a table that shows the water pressure in a pipe located at the base of the water tower as you vary the height of water in increments of 10 ft. Also plot water pressure vs. the height of water in feet. What should be the water level in the water tower to create 80 psi water pressure in a pipe at the base of the water tower?




We can see that in order to create a 80 psi water pressure in a pipeline at the base

of the tower, the water level in the water tower should be approximately 190 ft.

Trades & Technology

You might also like to view...

How much pipe remains in the scrap pile, in inches?

The inventory of a scrap pile is as follows: Channel iron, 87” Plate steel, 147” Key stock, 45” Pipe, 69” Flat iron strap, 208” A pipe support is welded using the following materials from the scrap pile: Channel iron, 61” Plate steel, 106” Key stock, 39” Pipe, 22” Flat iron strap, 189”

Trades & Technology

What should you do as you prepare to turn right at an intersection?

a. signal your turn, check for bicyclists, and do not turn directly in front of a bicyclist b. yield to bicyclists coming from the opposite direction c. honk your horn

Trades & Technology

The piston-cylinder arrangement in Problem 16.12 was designed and rated with an internal pressure of 6.45 MPa. Prior to shipping, the cylinder is tested by increasing the internal pressure to 3.0 times the design pressure (safety factor of 3.0). What maximum force in newtons must be applied to the piston to hold it stationary during the test?

What will be an ideal response?

Trades & Technology

A vehicle height sensor mounts to the body of the vehicle and may be connected to the ________ by a link

A) Upper control arm B) Frame C) Lower control arm D) None of these

Trades & Technology