Which of the following is NOT one of the most commonly used decimal units on industrial drawings?

A. One tenth                       0.10
B. One hundredth               0.01
C. One thousandth              0.001
D. One millionth                 0.000001


Answer: D

Trades & Technology

You might also like to view...

The nominal pipe size is an approximation of the pipe's _____.

a. circumference b. total wall thickness c. outside diameter d. inside diameter

Trades & Technology

A hydraulic system that uses a pilot oil system will:

a. Use lower pressure pilot oil to move the actuators slower b. Always have a pilot oil pump c. Use lower pressure oil to move the main control valve spools d. Will always have its relief valve set 1000 psi lower than main system pressure

Trades & Technology

In Figure 39-34, what is the difference between emergency heat operation and normal second stage heat operation?

What will be an ideal response?

Trades & Technology

Cutting a 2? (5 cm) aluminum plate requires a(n) _____

a. low gas flow rate b. high-cutting amperage c. low-cutting amperage d. oxygen/air plasma/shield gas combination

Trades & Technology