In certain cases, the function of a part may require locating and orienting a feature size at RFS. If the location and orientation of a hole are being controlled relative to the outside surfaces of the part and a tolerance of position at RFS is applied to the hole, the tolerance zone is located at the ____________________ position of the hole.
Fill in the blank(s) with the appropriate word(s).Fill in the blank(s) with the appropriate word(s).
ANS: true
You might also like to view...
According to the U.S. Bureau of Labor Statistics, directors and managers of major recreation facilities earn ____
A) substantially higher salaries B) minimally higher salaries C) ?low salaries but good benefits D) higher salaries but no benefits
What does the instruction, ORG 0000H do?
A) start of EPROM B) start of ROM C) end of RAM D) end of EPROM
The voltage between the "stinger" leg of a Delta transformer and ground is:
A) 120 volts. B) 208 volts. C) 277 volts. D) 240 volts.
A reference line has the notation "MT6" under it. What does this designation mean?
A. The maximum torsion destructive test is performed on 6 inches of the weld on the arrow side of the object. B. The magnetic particle nondestructive test is performed on 6 inches of the weld on the arrow side of the object. C. The metal arc welding process is performed on 6 inches of the weld on the arrow side of the object. D. The machine welding method of the welding process is performed on 6 inches of the weld on the arrow side of the object. E. none of the above