When is the tool head alignment checked with a dial indicator?
A) Before any precise machining square to the table is performed
B) Before any machining takes place
C) When any tool changing takes place
D) Once every day
A
You might also like to view...
Technician A says front riding height is reduced by worn control arm bushings. Technician B says front curb riding height is reduced by weak coil springs. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
What type of bearing is shown below?
A) Wedge bearing B) Axial bearing C) Roller bearing D) Tapered roller bearing
What are the three types of opposition to current flow that impedance represents?
What will be an ideal response?
Exhaust hoses should be used because one of the exhaust gases can be deadly in high concentrations. This gas is _________
A) Carbon dioxide (CO2 ) B) Hydrocarbons (HC) C) Oxides of nitrogen (NOx) D) Carbon monoxide (CO)