Technician A says that the camshaft turns at half of the crankshaft speed in a four-stroke cycle engine. Technician B says that the camshaft rotates at one-quarter the crankshaft speed. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
A
You might also like to view...
Technician A says that a pilot is placed into the valve guide to position the stone or cutter correctly for resurfacing the valve seat. Technician B says that he installed height should be checked and corrected with oversized valves, if needed. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Single-pole switches also have ____ printed on the switch lever.
a. OPEN and CLOSED b. UP and DOWN c. IN and OUT d. ON and OFF
The opening of the EGR valve pintle does NOT cause a change in the MAP sensor reading. This could cause ________
A) A high idle speed B) The engine to stall C) An EGR flow rate DTC to set D) The transmission to downshift
Two ways to determine the output of a BCD digital-to-analog converter are to:
A) sum the BCD weights of all bits that are 1s, or add the decimal value for each BCD code group and multiply that value by the step size. B) sum the straight binary weights of the input bits that are 1s, or determine the decimal value of the inputs and multiply this value by the step size. C) divide the straight binary weights of the input bits that are 1s by the full scale value, or determine the decimal value of the inputs and multiply that value by the step size. D) divide the full scale output value by the BCD weights of all bits that are 1s, or determine the decimal value for each BCD code group and multiply that value by the step size.