How is the data output from the EPROM sent back?
A) It is sent back into the microcontroller via port 1 and the 4 bits provided from port 3.
B) It is sent back into the microcontroller via port 0 and the 4 bits provided from port 2.
C) It is sent back into the microcontroller via port 0 and the 8 bits provided from port 2.
D) It is sent back into the microcontroller via port 1 and the 8 bits provided from port 3.
B
You might also like to view...
The common terminal of an ISO relay (terminal 30) is always connected to chassis ground.
Answer the following statement true (T) or false (F)
Most of the activities in FFA involve _____ on the local, state, and national levels
A) meetings? B) education? C) competitions? D) advisors
If a fault is detected in the electric power steering system, what dash light is turned on?
A) The "check engine" light B) The power steering warning light C) The "service vehicle soon" light D) Either B or C
During an AC performance test, an R-134a air conditioning system has a measured center duct outlet temperature of 59 degrees F. A manifold gage set shows low side pressure ranges between 35-45 psi and the high side pressure ranges from 250-400psi. Shop Temperature is 72 degrees F. What is most likely the cause?
a. The system has insufficient charge and may be leaking b. The system contains air with the refrigerant c. The TXV is restricted and not allowing enough refrigerant to flow d. The compressor is defective