A welding joint in which one flat part lies on top of another is a:
A. Butt joint
B. Lap joint
C. Edge joint
Answer: B
You might also like to view...
?An advantage of hot-leaf stamping is ____.
A. ?initial capital investment is not costly B. ?molding of parts is done at the same time as stamping C. ?no solvent clean up or disposal is needed D. ?multicolored transfers are relatively inexpensive
Sketch end views of the following weld joints in the spaces provided.
1. Lap joint beveled on both sides 2. Lap joint with J-groove on one side only 3. Corner joint with square edge preparation 4. Single bevel corner joint 5. Double V-groove
For most soldered or brazed joints, ____ is usually fairly low.
A. shear strength B. ductility C. fatigue resistance D. corrosion resistance
The component of a low-voltage thermostat assembly that the low-voltage wires are connected to is called a __________.
Fill in the blank(s) with the appropriate word(s).