What is distance B for the Fitup Table identified as part number 091220-28?
a. 29-1/2 inches
b. 28-7/16 inches
c. 23-1/2 inches
d. 48-1/2 inches
e. None of the above
c. 23-1/2 inches
You might also like to view...
The youngest portion of the leaf is cut off by the mower
Indicate whether the statement is true or false
Feed is the largest single cost item in the production of livestock
Indicate whether the statement is true or false.
The number of views shown on a drawing is determined by eliminating any views that are unnecessary.
Answer the following statement true (T) or false (F)
What should be done to unused inputs on TTL gates?
A) Unused AND and NAND inputs should be tied to Vcc through a 1k-ohm resistor; unused OR and NOR inputs should be grounded. B) All unused gates should be connected together and tied to Vcc through a 1k-ohm resistor. C) All unused inputs should be connected to an unused output; this will insure compatible loading on both the unused inputs and unused outputs. D) They should be left disconnected so as not to produce a load on any of the other circuits and to minimize power loading on the voltage source.