CNC programs are written in either conversational format or in the word address format

Indicate whether the statement is true or false


TRUE

Trades & Technology

You might also like to view...

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

What is the diameter of a circle with a circumference of 7 inches? Round to the nearest hundredth inch.

A. 2.22 B. 2.23 C. 2.24 D. 2.25

Trades & Technology

Define aquastat.

What will be an ideal response?

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. With variable torque loads, the torque varies as the square of the speed. 2. The electronic shear pin reacts to the amount—and rate —of current increase to the motor. 3. The half-wave rectifier circuit requires two diodes and the use of a center-tapped secondary AC transformer. 4. In a three-phase rectifier system, the DC level remains high and the ripple percentage is very low; therefore, the DC supply needs very little filtering. 5. The armature power is typically controlled by an SCR that is turned on at different points in the waveform to adjust the voltage to the motor armature to control the speed.

Trades & Technology