An optional method for determining feeder to schools is covered in _____.
a. NEC Section 90.9
b. NEC Section 220.86
c. NEC Table 515.3
d. NEC Article 555
b. NEC Section 220.86
You might also like to view...
While discussing electronically controlled transmissions, Technician A says as that line pressure is controlled by a pulse width modulated solenoid. Technician B says that the solenoid is controlled by the PCM. Who is correct?
A. Technician A B. Technician B C. Both A and B D. Neither A nor B
Which of the following acronyms is used to describe an engine piston that is at the exact bottom of its travel?
A. TDC B. BDC C. ATDC D. BTDC
Which acts like a safety valve that will release any excess pressure caused by too much heat or too much pressure within the cylinder?
A. pressure relief valve B. check valve C. fusible plug D. pop-off valve
Calibrating an instrument generally involves at least the two steps of zeroing the instrument and _____
A) spanning B) manipulating the actual process measured variable C) tuning the loop D) adjusting the minimum limit of the output range