A place for positioning the core in the mold is referred to as the ____.
A. core center
B. positioning plug
C. core print
D. mold zero point
E. none of the above
Answer: C
You might also like to view...
The purpose of a welded joint is to join parts together so that the ____.
A. weld does not interfere with the sliding B. least amount of scrap is produced C. the thickness of the joint will be acceptable D. completed weldment can withstand the stresses
Most modern automatic transmissions rely on mechanical, hydraulic, and electronic components to accomplish gear ratio changes.
Answer the following statement true (T) or false (F)
An antenna lead-in wire should have how many ohms of resistance between the center terminal and the grounded outer covering?
A) 5-50 ohms B) Infinity (OL) C) 300-500 ohms D) Less than 5 ohms
Technician Asays stability control is the controlled application and release of brakes at the correct time, independently of each other, to prevent an out of control vehicle during hard maneuvering. Technician B says there are two common terms for loss of steering control through a corner: understeer and oversteer. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B