The assembly method of estimating is less accurate than the single-rate methods.
Answer the following statement true (T) or false (F)
False
You might also like to view...
Design an active highpass filter with a high-frequency gain of 5 and a corner frequency of 200 Hz.
What will be an ideal response?
Technician A says that reprogramming a PCM using the J2534 system requires a factory scan tool. Technician B says that reprogramming a PCM using the J2534 system requires Internet access. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
An aftermarket satellite radio has poor reception. Technician A says that a lack of a proper ground plane on the antenna could be the cause. Technician B says that mountains or tall buildings can interfere with reception. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Answer the following statement(s) true (T) or false (F)
1. Rather than making a grounding connection in each service disconnecting means for services that are double-ended, it is permitted to make a single grounding electrode connection at the tie point for the services. 2. The purpose behind permitting the grounding electrode connection to be made at the equipment grounding conductor terminal bar of the service rather than to the neutral is to provide a convenient connection point sometimes outside the service disconnecting means enclosure. 3. Because separately derived systems are not a service, it is generally permitted to ground the neutral at multiple locations on the load side of the separately derived system. 4. Since the title of 250.52 is “Electrodes Permitted for Grounding,” the connection of these grounding electrodes is optional.