Technician A says that whenever using tension as a corrective force, the entire area between the attaching point and the anchor point is affected equally. Technician B says that when using tension, the pulling device will always attempt to seek its own center of the pulling line of force. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technicians A and B
D. Neither Technician A nor B
C. Both Technicians A and B
You might also like to view...
What procedure do most manufacturers recommend when a frame rail is damaged?
A. Repaired by welding B. Repaired by fishplating C. Reinforced with an inverted L-section D. Replacement
Ajinkya Electronic Systems, a company in India that manufactures many different electronic products, has to purchase goods and services from a variety of suppliers (wire, diodes, LED displays, plastic components, etc.). The table below shows several suppliers and the VAT tax rates associated with each. It also shows the purchases (in $1000 units) that Ajinkya made (before tax) from each supplier in the previous accounting period. Assume Ajinkya’s sales to end users were $9.2 million and Ajinkya’s products carry a 15% VAT.
 FIGURE 1.png)
What was the average VAT rate paid by Ajinkya in purchasing goods and services?
With which signal pattern is the RMS reading the same as the average reading?
A) Square wave B) Sine wave C) Nonsymmetric D) None of these
The profiles for baseboard convectors and forced-air systems reveal lower than ideal temperatures near the floor, as well as higher than ideal temperatures near the ceiling. This undesirable effect is called air temperature ____.
a. discharge b. stratification c. modulation d. wastage