In the figure above, the purpose of the M1 normally closed contacts shown in the control circuit is to _____
a. provide memory for the Start switch
b. prevent the drain pump from operating when the fill pump is operating
c. prevent the fill pump from operating when the drain pump is operating
d. provide memory for the float switch
b
You might also like to view...
A typical transaxle repair kit includes ________.
A) Snap rings B) Seals C) Gaskets D) All of the above
____________________ is a digital multimeter.
Fill in the blank(s) with the appropriate word(s).
The contactor contacts must be in good condition to ensure that the proper voltage reaches the load.
Answer the following statement true (T) or false (F)
A belt that vibrates and jumps around while operating can most likely be corrected by:
A) Tightening the belt. B) Spraying the belt with belt dressing. C) Replacing the belt. D) Aligning the belt.