Refer to Figure P6.4 and the parameter values listed in Problem 6.76:
R1 = 300?, R2 = R3 = 500?, L = 4H, C1 = 40?F, C2 = 160?F.
a. Determine the frequency response:
Repeat parts b and c (below) of Problem 6.76 for this frequency response.
b. Sketch, by hand, the associated Bode magnitude and phase plots. List all the steps in constructing the plot. Clearly show the break frequencies on the frequency axis. (Hint: Use the MatlabTM command “roots” or a calculator to quickly determine the polynomial roots.)
c. Use the MatlabTM command “Bode” to generate the same plots. Verify your sketch.
Analysis:
You might also like to view...
Technician A says to use two flare nut wrenches to disconnect transmission cooler lines. Technician B says to use vice grip pliers to hold a cooler line that is twisting as the flare nut is turned and then replace the line and fitting. Who is correct?
A. A only C. Both A and B B. B only D. Neither A nor B
Floating-angle construction helps to eliminate nail popping and _____.
a. the need for adhesives b. corner cracking c. overlapping d. joint compound
The binary number system uses just two digits
Indicate whether the statement is true or false
The output coil of a relay ladder diagram is capable of controlling only one contact.
Answer the following statement true (T) or false (F)