To prevent blowing the meter fuse in a DMM ________

A) Never test resistance of an energized circuit B) Install a fuse in line with the meter lead
C) Both A and B D) Neither A nor B


C

Trades & Technology

You might also like to view...

IDENTIFY TEST PROCESS SYMBOLS AND DIAGRAMS

Trades & Technology

Orthographic projection in which the right-side view is shown to the left of the front view is

A. First-angle projection B. Third-angle projection

Trades & Technology

What type of diagnostic trouble codes will be set when an EPS system fault is detected?

A) Type A code B) Type B code C) Type C code D) Type D code

Trades & Technology

Assuming they both have the same condenser temperature, which application requires more horsepower to produce a ton of cooling: a 0°F evaporator, or a 40°F evaporator?

A) The 0°F evaporator, because of the higher pressure difference B) The 40°F evaporator, because of its higher pressure C) The horsepower requirement is too complicated a calculation to make any valid comparison based only on evaporator and condenser temperatures. D) The horsepower requirement per ton of cooling is not affected by the evaporator temperature.

Trades & Technology