What is the virtual condition of a pin with a diameter of 12.00 ± 0.25 mm and a perpendicularity geometric tolerance of .05?
a. 11.70
b. 12.25
c. 12.30
d. 12.75
c. 12.30
You might also like to view...
Match these refrigerants (insert number) with their properties listed below.
(1) R-12 (2) R -134A (3) R-410A (4) R-717 A. ________Environmentally friendly, but flammable and toxic. B. ________Banned by Montreal Protocol due to high ODP. C. ________On its way out due to high GWP. D. ________Was a replacement for R-22
A wire service is a(n) ____________________ for floral orders
Fill in the blank(s) with correct word
Exhaust passages are included in some intake manifolds. Technician A says that the exhaust passages are used for exhaust gas recirculation (EGR) systems. Technician B says that the exhaust heat is used to warm the intake charge on some engines equipped with a throttle-body-type fuel-injection system. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Which of the following procedures would be used to check the parallel loading feature on a counter?
A) Apply LOWs to the parallel DATA inputs, pulse the CLK input and check for LOWs on all the Q outputs. B) Apply HIGHs to all the Q terminals, pulse the CLK and check to see if the DATA terminals now match the Q outputs. C) Preset the LOAD inputs, set the CLR to its active level and check to see that the Q outputs match the values preset into the LOAD inputs. D) Apply HIGHs to all the DATA inputs, pulse the CLK and CLR inputs, and check to be sure that the Q outputs are all LOW.