Increasing the armature spring force will result in _____.
a. higher drop-out values
b. lower current values
c. lower drop-out values
d. lower pull-in voltage
a. higher drop-out values
You might also like to view...
The first step in repointing is to remove any of the old deteriorated mortar joints using a special _____, which is still the least expensive and best method for small jobs .
A. pin grinder B. hydraulic breaker chisel C. masonry grinder D. plugging chisel
Which aspects of contractual arrangements are covered in the Special and General Conditions portions of a specification?
a. Nontechnical b. Technical c. Equipment and materials d. Regulatory compliance
Technician A says before assembling a transaxle, the seals and bearings should be lubricated with clean bearing grease. Technician B says when reassembling a transaxle, seals can be reused if they are not damaged. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
The SCR turns off by __________.
A. reducing the holding current value B. removing the positive potential at the gate C. both A and B